產品用途
Scope of application
本產品適用于交流額定電壓450/750V及以下動力,日用電器、儀器、儀表及控制用銅芯聚氯乙烯絕緣電線(電纜。)
This product is fit for power supply with rated AC voltage up to 450/750V, or serves as copper core PVC insulated electric wires for daily electrical appliances, instruments and meters and control equipment.
使用特性
Service characteristics
電纜的長期允許工作溫度:BV-90、RV-90應不超過90℃,其它型號不超過70℃固定敷設用電纜(電線)的敷設溫度不低于0℃。
允許彎曲半徑:電纜外徑(D)小于25mm者應不小于4D,電纜外徑(D)25mm及以上者應不小于6D。
Long tem service temperature: BV-90 and RV-90 not exceeding 90℃, other models not over 70℃; permanently laid cables not lower than 0℃.
Bending radius allowed: for cables with outer diameters (D) lower than 25mm: not less than 4D; if the outer diameter is 25mm or more, the bending radius shall not be less than 6D.
型號名稱及規格(見表1)
Models, names and specifications (see table 1)
產品名稱 Product names | 型號 Models | 額定電壓V Rated voltage | 芯數 No. of cores | 標稱截面(mm2) Nominal Sectional area | 長期工作溫度℃ Long-tem service temperature |
一般用途單芯硬導體無護套電纜 Single-core, hard conductor unsheathed cable for general use | 2271IEC01(BV) | 450/750 | 1 | 1.5~240 | 70 |
一般用途單芯軟導體無護套電纜 Single-core, soft conductor unsheathed cable for general use | 2271IEC02(RV) | 1 | 1.5~240 | ||
內部布線用導體溫度為70℃的單芯實心導體無護套電纜 Single-core, solid conductor unsheathed cable for interior wiring, conductor temperature 70℃ | 2271IEC05(BV) | 300/500 | 1 | 0.5~1.0 | |
內部布線用導體溫度為70℃的單芯軟導體無護套電纜 Single-core, soft conductor unsheathed cable for interior wiring, conductor temperature 70℃ | 2271IEC06(RV) | 1 | 0.5~1.0 | ||
內部布線用導體溫度為90℃的單芯實心導體無護套電纜 Single-core, solid conductor unsheathed cable for interior wiring, conductor temperature 90℃ | 2271IEC07(BV-90) | 1 | 0.5~2.5 | 90 | |
內部布線用導體溫度為90℃的單芯軟導體無護套電纜 Single-core, soft conductor unsheathed cable for interior wiring, conductor temperature 90℃ | 2271IEC08(RV-90) | 1 | 0.5~2.5 | ||
輕型聚氯乙烯護套電纜 Light PVC-sheathed cables | 2271IEC10 (VV) | 2-5 | 1.5~3.5 | 70 | |
普通聚氯乙烯護套軟線 General PVC-sheathed soft cables | 2271IEC53 (RVV) | 2-5 | 0.75~2.5 | ||
輕型聚氯乙烯護套軟線 Light PVC-sheathed soft wire | 2271IEC52 (RVV) | 300/300 | 2-3 | 0.5~0.75 | |
扁型護套軟線 Flat unsheathed soft wire | 2271IEC42 (RVB) | 300/300 | 2 | 0.5~0.75 | 70 |
技術要求及參數
Technical requirements and parameters
1)導體均按GB/T3956-1997《電纜的導體》標準規定要求。
2)絕緣用聚氯乙烯材料要求,耐溫90℃電線電纜應采用PVC/E型聚氯乙烯混合物材料,其余耐溫70℃的均用PVC/C型聚氯乙烯混合物材料擠包絕緣層。
3)內護層采用非硫化型橡皮或塑料混合物擠包;護套層采用PVC/ST4型聚乙烯混合物材料擠包。
4)產品性能要求及試驗方法,按本標準(GB5023.1、2、3)規定,進行檢測,全部通過則為合格品。